|
The Itronics ITB-100HD SP Smart Plus DVR is an update to the very popular Itronics ITB-100HD.
Compact Korean built dash cam with very good picture quality during the day and good picture quality at night.
It has a number of improvements over the ITB-100HD including:
Records 1080p at 30f/s instead of 24f/s
The boot-up time is reduced to approximately 15 seconds instead of 30 seconds.
Has voice capability that will verbally inform the driver on any major status changes
A white LED light in the front of the camera
The bitrate for the ITB-100HD SP is somewhat low at 6 MB / sec and is not adjustable (same as the original ITB-100HD).
It has a built-in GPS module and uses standard SD cards.
This dash camera also has a G-sensor and parking mode.
Full HD 1080p video resolution Itronics ITB-100 HD SP Dash Camera
The ITB-100’s 2-megapixel CMOS Sensor captures continuous loop video up to Full HD 1080p in quality, which is then stored in separate files (the length of which can be altered in minutes). Once the SD Card is full, the camera will re-write over old video footage.
Built-in GPS in Dash Cam
Track your speed and location on your video with the ITB-100 HD SP’s built-in GPS module, which adds an accompanying overlay to your HD video.
Auto-Parking Mode
Hard-wire the camera to your vehicle and ‘Parking Mode’ can be enabled. In essence, this turns the iTronics into a vehicle CCTV camera that records and stores video through motion detection. If someone is tampering with your vehicle, or simply walks past it, the camera will detect and store. When in parking mode the camera runs off the car battery. Whilst it uses such a minimal amount of power that it would take days to drain the stationary car’s battery fully, a Battery Discharge Prevention Device is recommended as a precaution.
3-axis G-Sensor - Separate Event Files
This internal G-Sensor enables the ITB-100 HD to store video based on shock detection. So large bumps in the road, sharp braking or collisions will automatically be stored to the SD Card. The level of shock that the camera determines significant enough to record can be adjusted for your convenience.
Auto start/stop Dash Camera
The camera takes approximately 15-seconds to start recording once it receives power and around 60-seconds to obtain a GPS signal. ‘Parking Mode’ becomes active once the camera has been stationary for 5-minutes, and will only store data based on motion-detection, rather than continuously recording everything.
Built-in Super Capacitor
This internal backup battery’s primary function is to prevent you losing crucial data in the event of a collision heavy enough to disconnect or damage the camera. If it is disconnected, it will stay powered just long enough to store potentially crucial HD video of the incident.
Optional Audio
Recording the sounds of the road to accompany the visuals is entirely optional, so it depends on which is most appropriate for your requirements. Incidentally, this Mic On/Off button is the only button that features on the camera; everything else happens automatically, with settings changeable on the computer
SECTION
ITB100 - HD
Camera
Lens
1 /2.7” large CMOS
Pixel / Angle
2 Megapixels / 144 Degree
Recording
Compression Method
H.264
Variable Resolution
FULL HD 1920 x 1080 , HD 1280 x 720 , D1 720 x 480
Variable Frame
15 , 24 , 30 f/s
3 – Axis Acceleration Sensor
Built-in
Special specifications
Automatic Running Mode
Available
GPS
Built-in
Video Out
Supported (NTSC)
Voice Recording
Built-in Mic
Rated Power
DC 12 ~ 24V
RTC
Built-in
Dimension
96.2mm(L) x 40.4mm(H), 80g
Act Temperature
-20 Degree ~ 70 Degree Centigrade
|
